Using stripper to remove paint and stain from wood furniture is a messy process. After the stripper has dissolved the finish you need to remove it from the wood fairly quickly and as thoroughly as possible. Using a scraper works great on flat surfaces but is no help on spindles and recessed areas. Washing it off with water just creates more mess and also gets the wood wet.
The best technique I have found to solve this problem is to use sawdust. The sawdust works two ways.
It is very absorbent : the sawdust acts like a sponge and soaks up the stripper quickly and is much easier to dispose of.
It is abrasive : once the majority of stripper has been removed a handful of fresh sawdust can be used like sand paper to complete the removal of any remaining finish and stripper on spindles, crevices, and hard to reach areas.
Check with your local junior high or high school wood shop teacher and you very likely can get a big bag of sawdust free.
Subscribe to:
Post Comments (Atom)
Good tips Jeff. I wonder if kitty litter would work in a similar way - albiet a bit more aeromatic! Of course, you'd have to use the non-clumping type. We used to use kitty litter on the floor of the garage to soak up automobile fluids before they stained.
ReplyDeleteKitty litter works well to soak up fluids but not as well as sawdust for furniture restoration. Kitty litter is clay and crushes, sticking to the furniture. Sawdust is finer and has the abrasive properties to remove paint and stain.
ReplyDeleteI tried kitty litter once and quickly switched back to using sawdust.